- 96 - © 2018 unitech Electronics Co., Ltd. All rights reserved.unitech is a registered trademark of unitech Electronics Co., Ltd.MS282 User’s Manual3.12.1 Set Lengths for Matrix 2 of 5The length of a code refers to the number of characters (i.e., humanreadable characters), including check digit(s) the code contains. Setlengths for Matrix 2 of 5 to any length, one or two discrete lengths, orlengths within a specific range. The default is One Discrete Length: 14.Note: When setting lengths, enter a leading zero for single digit numbers.Scan one of the following bar codes to select a length option:• One Discrete Length - Decode only Matrix 2 of 5 symbols containing aselected length. Select the length using the barcodes in Appendix B, Numeric Bar Codes. Forexample, to decode only Matrix 2 of 5 symbolswith 14 characters, scan Matrix 2 of 5 - OneDiscrete Length, and then scan 1, 4. To correct anerror or change the selection, scan Cancel.• Two Discrete Lengths - Decode only Matrix 2 of 5 symbols containingeither of two lengths. Select lengths using the barcodes in Appendix B, Numeric Bar Codes. Forexample, to decode only Matrix 2 of 5 symbolscontaining either 2 or 14 characters, scan Matrix2 of 5 - Two Discrete Lengths, and then scan 0, 2,1, 4. To correct an error or change the selection,scan Cancel.• Length Within Range - Decode Matrix 2 of 5 symbols with a specificlength range. Select lengths using the bar codesin Appendix B, Numeric Bar Codes. For example,to decode Matrix 2 of 5 symbols containingbetween 4 and 12 characters, scan Matrix 2 of 5- Length Within Range, and then scan 0, 4, 1, 2.To correct an error or change the selection, scanCancel.•Any Length - Decode Matrix 2 of 5 symbols containing any number ofcharacters within the engine’s capability.
