- 77 - © 2018 unitech Electronics Co., Ltd. All rights reserved.unitech is a registered trademark of unitech Electronics Co., Ltd.MS282 User’s Manual3.7.1 Set Lengths for Interleaved 2 of 5The length of a code refers to the number of characters (i.e., humanreadable characters), including check digit(s) the code contains. Setlengths for I 2 of 5 to any length, one or two discrete lengths, or lengthswithin a specific range. The default is One Discrete Length: 14.Note: When setting lengths, enter a leading zero for single digit numbers.Scan one of the following bar codes to select a length option:• One Discrete Length - Decode only I 2 of 5 symbols containing a selectedlength. Select the length using the bar codes inAppendix B, Numeric Bar Codes. For example, todecode only I 2 of 5 symbols with 14 characters,scan I 2 of 5 - One Discrete Length, and then scan1, 4. To correct an error or change the selection,scan Cancel.• Two Discrete Lengths - Decode only I 2 of 5 symbols containing either oftwo lengths. Select lengths using the bar codesin Appendix B, Numeric Bar Codes. For example,to decode only I 2 of 5 symbols containing either2 or 14 characters, scan I 2 of 5 - Two DiscreteLengths, and then scan 0, 2, 1, 4. To correct anerror or change the selection, scan Cancel.• Length Within Range - Decode I 2 of 5 symbols with a specific lengthrange. Select lengths using the bar codes inAppendix B, Numeric Bar Codes. For example,to decode I 2 of 5 symbols containing between 4and 12 characters, scan I 2 of 5 - Length WithinRange, and then scan 0, 4, 1, 2. To correct anerror or change the selection, scan Cancel.•Any Length - Decode I 2 of 5 symbols containing any number of characterswithin the engine’s capability
