- 29 - © 2018 unitech Electronics Co., Ltd. All rights reserved.unitech is a registered trademark of unitech Electronics Co., Ltd.MS282 User’s Manual2.13 Prefix/Suffix ValuesYou can append a prefix and/or one or two suffixes to scan data for use indata editing. To set a value for a prefix or suffix, scan one of the followingbar codes, and then scan four bar codes from Appendix B, Numeric BarCodes that correspond to that value. See Appendix A, ASCII CharacterSets for the four-digit codes. When using host commands to set the prefixor suffix, set the key category parameter to 1, and then set the 3-digitdecimal value. See Appendix A, ASCII Character Sets for the four-digitcodes.The default prefix and suffix value is 7013 (Enter key).To correct an error or change a selection, scan Cancel.NOTE: To use Prefix/Suffix values, first set the Scan Data Transmission Format.Scan PrefixScan Suffix 1Scan Suffix 2Data Format Cancel
