Notes on the documentation4 Installation instructions geoTHERM 0020051574_0411 Notes on the documentationThe following instructions are intended to guide youthrough the entire documentation. Other documents arevalid in connection with these installation instructions.We accept no liability for any damage caused by failure toobserve these instructions.1.1 Observing other applicable documents> When installing the heat pump, you must observe allinstallation instructions for parts and components of theheating installation. These installation instructions areincluded with the individual parts of the heating installa-tion and any supplementary components.You must also observe all operating instructions thataccompany the components of the heating installation.1.2 Document storage> Pass these installation instructions and all other applica-ble documents and, if necessary, any required tools tothe system operator. The system operator will be respon-sible for storing them so that the instructions and toolsare available when required.1.3 Symbols usedThe symbols used in the manual are explained below. Dan-ger symbols for identifying dangers are also used in thismanual (¬ Ch. 2.1.1).i Symbol denoting additional useful tips andinformation> Symbol for a required task1.4 Applicability of the instructionsThese installation instructions apply only for heat pumpsthat have the following article numbers:Type name Article numberBrine-Water Heat Pumps (VWS)VWS 220/2 0010002797VWS 300/2 0010002798VWS 380/2 0010002799VWS 460/2 0010002800Water-Water Heat Pumps (VWW)VWW 220/2 0010002801VWW 300/2 0010002802VWW 380/2 0010002803VWW 460/2 00100028041.1 Type designations and article numbersThe 10-digit article number for the heat pump (this corre-sponds to the 10 digits that come after the 7th digit of theserial number) can be found on the sticker on the heatpump or on the identification plate (¬ Ch. 3.1).
