49© Vallox Oy - All rights reserved49© Vallox Oy - All rights reservedCleaning the extract air fanTo clean the extract air fan, proceed as follows:1. Disconnect the ventilation unit from the mains electricity supply.2. Lift the latch to open the door of the Vallox ventilation unit.3. Lift the door off.CAUTIONThe door is heavy.4. Remove the filters (C), the cell top support (E) and the heat recovery cell(D). See chapters “Replacing the filters” and “Cleaning the heat recoverycell”.5. Open the four screws (figure 1) on the extract air fan cover and removethe cover (figure 2). The fan can now be cleaned in place.6. To remove the fan for cleaning:a. Push the fan gently upward (figure 3).b. Pry the plastic lock to the right of the fan with a screwdriver, forexample (figure 4).c. The fan falls downwards (figure 5).d. Pull the fan out of the unit.e. Disconnect the fan wire quick connector (figure 6).7. Clean the fan.8. To reassemble the ventilation unit, follow the above steps in reverseorder.9. Close the door and plug the unit back into the mains. The extract air fanhas now been checked and cleaned.1 324 5 6MAINTENANCE
