Valor Fires 940 Installer And Owner Manual

Contents

Valor Fires 940 Installer And Owner Manual Manual pdf 39 page image

position for a further 10 seconds to allow the pilot flame to stabilise.3. Release the button. The button should automatically spring up to the low heatposition. If for any reason the slider control does not spring up, raise the slider to thetopmost (Off) position and investigate why the slider is not operating correctly. If theflames go out at this stage or when checking the rest of the setting positions, try thefull lighting sequence again. If the flames fail after two attempts, investigate the pilotunit.4. Gradually slide the button up to increase the burner setting. The burner should beat its maximum setting at the high heat position shown in figure 45. You should feel acheck to the button movement at this position.5. Slide the control button up past the high heat position to the off (“O”) position at thetop of the slide slot. Both pilot and main burner should go out. While cooling theceramic fuel effect may make some crackling noises. This is quite normal.15.2 Check for spillage.1. Close all doors and windows in the room containing the appliance.2. Light the appliance and set the slide control to the maximum burning position.3. Leave the appliance on for five minutes.4. The smoke match should be placed horizontally into the convection box at the righthand side. There is a notch in the black cross member. Insert the tube so that theneck of its flared end is 5mm passed and in contact the cross member (See figure46).The installation is satisfactory if the smoke is drawn into the appliance.If the smoke is not drawn into the appliance leave the appliance alight at themaximum setting for a further tenminutes and then repeat the test. If thesmoke is still not drawn into theappliance inspect the sealing to thefireplace surround. If the sealing issatisfactory but the appliance is installedwith the flue restrictor (See section 8point 8) remove the restrictor, reseal theappliance and retest. If smoke is still notdrawn into the appliance disconnectthe appliance and seek expert advice.5. If the above test is satisfactory openall internal connecting doors, hatches,etc. in the room. Keep all doors andwindows that open to the outside of thePage 39© Baxi Heating U.K. Limited 2009.Figure 46. Smoke match tube position(Shown with ‘Visage’ fascia)INSTALLER GUIDEA spillage check must be made before leaving the installed appliance with thecustomer. Make this with all the ceramic fuel effect pieces and complete fasciaand firefront in position.