Valor Fires 963 Installer And Owner Manual

Contents

Valor Fires 963 Installer And Owner Manual Manual pdf 39 page image

19. FINAL REVIEW1. COMPLETE THE INFORMATION IN THE WARRANTY AND SERVICE SECTIONOF THE OWNER GUIDE (See last pages of the OWNER guide).2. Visually inspect the appliance. Clean off any marks incurred during installation.3. Advise the customer how to operate the fire.4. Explain to the customer that the appliance has a flame failure and spillagemonitoring system. Point out the explanation of this system shown in the owner guide.Advise that if the fire goes out for any reason, wait at least three minutes beforerelighting. Stress that if the monitoring system repeatedly shuts off the fire, theappliance should be switched off and a competent person should be consulted.5. Advise that the fire may give off a slight odour while new. This is quite normal and itwill disappear after a few hours of use.6. Advise that any cleaning must only be carried out when the fire is off and cold.7. Advise the customer that they should read the owner guide before operating thefire and always follow the advice in the section headed “Cleaning your fire”.8. Advise the customer that the appliance will operate to its maximum potential if theflue is primed during the first 20 – 30 minutes of use. To do this, simply set the controlto its highest setting. This will also burn off any carbon deposits that may have formedduring previous use.If using the appliance for long periods it is beneficial to change between settings. Thiswill also help to remove any carbon deposits that may form during use.9. Recommend that the appliance should be serviced and the chimney inspected by acompetent person at least annually.If the appliance is in premises in the United Kingdom occupied by a tenant, point outthat by law a landlord must have any gas appliance, flue and pipework which issituated in a tenant’s premises checked for safety at least every 12 months.10. Advise the customer that the fascia, window and ceramic pieces can be cleanedas described in the owner guide and that the loose ceramic fuel effect pieces must bereplaced as described in the instructions supplied with them.Stress that no extra ceramic fuel effect pieces must be added over and abovethose supplied with the appliance and that any replacements must only be theauthorised spares. Warn that ignoring this advice could cause incompleteclearance of the products of combustion with consequent health hazards.11. Inform the customer that the Serial number for the appliance is located onthe information label, located behind the lower front casting and underneath theburner (See figure 8 on page 62).12. Hand the literature pack with this guide to the customer.Page 39© Baxi Heating U.K. Limited 2010.INSTALLER GUIDE