Valor Fires 963 Installer And Owner Manual

Contents

Valor Fires 963 Installer And Owner Manual Manual pdf 42 page image

20.4 To remove the fascia.1. Remove the firefront casting and the front covercasting.2. Remove the two screws and washers securingthe bottom of the fascia to the sides of theconvection box.3. Carefully lift the fascia upward to clear the uppersupport bracket on the convection box (See figure38). Pull the fascia clear and place carefully aside.4. Refit in the reverse order. Make sure that thefascia is properly located over the upper supportbracket. See section 16 of this guide for detailedfitting instructions.20.5 To remove the window.1. Remove the firefront casting and the front covercasting.2. Detach and remove the windowassembly. To do this unscrew andremove the two thumbscrews at thebase of the window assembly. Gentlylift the window assembly upward andforward (See figure 39). Place thewindow assembly and thumbscrews ina safe place away from the work area.20.6 To remove the burner unit.1. Remove the firefront casting and thefront cover casting.2. Remove the loose ceramic fueleffect.3. Support the inlet ‘T’ connector toavoid straining the pipework anddisconnect the appliance from the inlet‘T’ connector.4. Unscrew and remove the screw thatsecures the slider arm assembly to theburner.5. Detach the burner unit from the convectionbox by removing two screws (See figure 40).6. Replace in the reverse order (When fittingthe screw that connects the control slider tothe burner use a screwdriver - do not leaveas finger tight only).Page 42© Baxi Heating U.K. Limited 2010.INSTALLER GUIDEFigure 40.Figure 39.Figure 38.