115LightingDoor-to-door lightingThe dipped beam remains switched on forapprox. 30 seconds once you have left thevehicle and closed the driver’s door.To activate1. Switch off ignition.2. Remove ignition key.3. Open driver’s door.4. Pull turn signal stalk towards steeringwheel.5. Close driver’s door.If the driver’s door is left open, the lights willextinguish after two minutes.The light is switched off immediately byinserting the key into the ignition or pullingthe turn signal stalk towards the steeringwheel again.Switching on the exterior lightingwith the remote control 3The lead-me-to-the-vehicle light functionswitches the dipped beam on for approx.30 seconds.Programme functionThis function can be activated anddeactivated depending on the key used -see "Personalised key" on pages 40, 42(P1).To activatePress button q on the remote control twicewhen the vehicle is locked.Country-specific application 3: To switchon the lead-me-to-the-vehicle lightfunction, press button q on the remotecontrol once the vehicle is locked.Switching on the ignition or pressingbutton p on the remote control willdeactivate the lead-me-to-the-vehicle lightfunction early.Ofrecido por www.electromanuales.com
