Self-help 117z Do not disconnect the dischargedbattery from the vehicle.z Switch off all unnecessary electricalconsumers.z Do not lean over the battery during jumpstarting.z Do not allow the terminals of one lead totouch those of the other lead.z Do not touch the vehicles while jumpstarting.z Apply handbrake. Transmission inneutral (Tecshift 3 in N).z Do not connect leads to negativeterminal of discharged battery!z The connection point should be as faraway from the discharged battery aspossible.z Route the leads so that they cannotcatch on rotating parts in the enginecompartment.z Start the engine of the vehicle providingthe jump start.z After 5 minutes, start the other engine.Start attempts should be made atintervals of 1 minute and should not lastlonger than 15 seconds.z After starting, allow both engines to idlefor approx. 3 minutes with the leadsconnected.z In order to avoid excess voltage in theelectrical system, before removing alead, switch on an electrical consumer(e.g. light, heated rear window 3 ) in thevehicle receiving the jump start.z Reverse above sequence exactly whenremoving leads.Jump start terminalIn the event of a discharged battery, thejump start terminal enables the vehicle tobe started without the need to access thebattery inside the vehicle.The jump start terminal is located in theengine compartment and identified by a“+” sign on the red insulating cover.Lift the red insulating cover to access theterminal connector. Ensure the redinsulating cover is latched back intoposition when not in use.Ofrecido por www.electromanuales.com