100 Process Image WAGO-I/O-SYSTEM 750750-464 2/4 AI RTD configurableManualVersion 1.0.17.6.3 NTC 10 kOhm ThermokonWith the setting "NTC 10 kOhm Thermokon" and activated Siemens format, theI/O module converts the resistance measured values of NTC 10 kOhm Thermokonresistance sensors and outputs them as temperature values.The temperature values are displayed at a resolution of 1 digit per 0.5 °C.The status information is depicted in bit 0 to bit 2 and the digitalized measuredvalue in bit 3 to bit 15.Table 85: Process image for 750-464/020-000, NTC 10 kOhm Thermokon settingTemperature°CResistancekΩNumeric value 1) with status information 4) Status-byteHex.LEDerrorAI 1, 2Binary XFÜ Hex. Dec.< -40.0 >426.48 '1111.1101.1000.0 001' 0xFD81 -639 0x41 onUnderrange 3)-40.0 426,48 '1111.1101.1000.0 000' 0xFD80 -640 0x00 off-30.0 210,08 '1111 1110 0010 0 000' 0xFE20 -480 0x00 off0.0 34,28 '0000.0000.0000.0 000' 0x0000 0 0x00 off25.0 10,00 '0000.0001.1001.0 000' 0x0190 400 0x00 off50.0 3,53 '0000.0011.0010.0 000' 0x0320 800 0x00 off100.0 0,67 '0000.0110.0100.0 000' 0x0640 1600 0x00 off150.0 0,185 '0000.1001.0110.0 000' 0x0960 2400 0x00 off> 150.0 0,185 '0000.1001.0110.0 001' 0x0961 2401 0x42 onOverrange 3)--- < 0.009 '0000.1001.0110.0 011' 0x0963 2403 0x52 onShort circuit2)1) Temperature values below 0 °C are represented in two's complement binary.2) When short circuit and wire break monitoring is ON (see section "Behavior in the Event of anError")3) When underrange / overrange limit is ON (see section "Behavior in the Event of an Error")4) Status information: X: Not used, F: Short circuit, wire break, Ü: OverrangePos : 97 /D okumentation allgemei n/Glieder ungs elemente/---Seitenwechs el--- @ 3\mod_1221108045078_0.doc x @ 21810 @ @ 1
