14 Important Notes WAGO-I/O-SYSTEM 750758-874/000-110 WAGO-I/O-IPC-C6ManualVersion 2.3.0Pos: 19 /Serie 758 (Funk, IPC und PFC)/Wichtige Erläuterungen/Bestimmungsgemäße Verwendung 758-87x 1 @ 10\mod_1312347331946_21.doc @ 75550 @ 3 @ 12.1.3 Use in Compliance with Underlying ProvisionsThe I/O-IPC is used exclusively for controlling automated tasks and Linuxapplications. Therefore, it shall not be used for transmitting and processingsecurity-related information; i.e., for example, emergency stops shall not becarried out on this equipment.Pos: 20 /Serie 758 (Funk, IPC und PFC)/Wichtige Erläuterungen/Bestimmungsgemäße Verwendung 758-87x 3 @ 10\mod_1312347595624_21.doc @ 75558 @ @ 1The I/O-IPC is a class A device and can cause radio interference in residentialareas. If this is the case, you shall only use the I/O-IPC after measures have beentaken to reduce emitted interference.The I/O-IPC was developed for applications requiring IP20 protection.The I/O-IPC shall only be used as a unit or in combination with the 750/753Series I/O Modules.Up to 64 750/753 series I/O modules may be connected to the I/O-IPC. The use ofup to 250 I/O modules is possible with the WAGO internal data bus extension(optional). When doing so, the following system parameters shall be observed:• The total length of the I/O modules behind the I/O-IPC, including the endmodule, shall not exceed a maximum of 780mm.• The maximum size of the process image for the input and output data shallnot exceed 500 bytes in each case.Applications other than those described in these instructions are not permitted.Pos: 21 /Alle Serien (Allgemeine Module)/Wichtige Erläuterungen/Technischer Zustand der Geräte - Überschrift 3 und Inhalt @ 3\mod_1221060446109_21.doc @ 21723 @ 3 @ 12.1.4 Technical Condition of Specified DevicesThe components to be supplied Ex Works, are equipped with hardware andsoftware configurations, which meet the individual application requirements.WAGO Kontakttechnik GmbH & Co. KG will be exempted from any liability incase of changes in hardware or software as well as to non-compliant usage ofcomponents.Please send your request for modified and new hardware or softwareconfigurations directly to WAGO Kontakttechnik GmbH & Co. KG.Pos: 22 /Dokumentation allgemein/Gliederungselemente/---Seitenwechsel--- @ 3\mod_1221108045078_0.doc @ 21810 @ @ 1
