Wacker Neuson G 70 Operator's Manual

Also see for G 85: Repair manual

Contents

Wacker Neuson G 70 Operator's Manual Manual pdf 43 page image

G 50/G 70/G 85 Operationwc_tx000483gb.fm 433.28 Automatic/Remote Start-upSee Graphic: wc_gr002611In the “REMOTE START” position the generator can be startedremotely, either through a transfer switch or some other type of remotestart switch. “REMOTE START” is the normal setting when using thegenerator as a standby power supply. Before placing the generator inthe automatic start-up mode, review the pre-start and manual Start-upsections in this manual and follow procedure below.Before placing the Engine Start Switch (f) in the “REMOTESTART” position, verify that the contacts on any remote switch linkedto the generator set are OPEN. This will prevent the generator fromimmediately starting when the Engine Start Switch is moved to the“REMOTE START” position.3.28.1 Perform a manual start at least once to verify that the metering panelis operating correctly. Refer to Section Before Starting and ManualStart-up sections in this manual.3.28.2 If a check of auto start-up circuit is desired, attach a short jumper wire(minimum 16 gauge insulated) between the two terminals on theremote run terminal block. This applies a ground to the Engine ControlModule to complete the start circuit. The engine should crank, start andrun.Move the Engine Start Switch to off “O” to stop engine. Remove jumperfrom remote run terminals after testing is complete.3.28.3 Secure generator by closing and locking all doors.3.28.4 Set Engine Start Switch to “REMOTE START” and close main linecircuit breaker.The generator is now ready for automatic start-up.If the generator is to be used as a stand-by power supply for more thana month, provisions must be made to maintain battery charge. This canbe done either by attaching a battery charger to the battery or bystarting generator manually and running engine periodically tomaintain charge. See Section Manual Start-up.WARNING