Waldorf RN8410G Installation And Operation Manual

Also see for RN8410G: Installation and operation manual Installation and operation manual

Waldorf RN8410G Installation And Operation Manual Manual pdf 11 page image

9InstallationClearancesNOTE: Only non-combustible materials can be used in close proximity to this appliance.* Side clearances can be 50mm when adjacent surface is at least 100mm below cooking surface.AssemblyNOTE: All Models are delivered completely assembled. No further assembly is required. This appliance is fitted with adjustable feet to enable appliance to be positioned securelyand level. This should be carried out on completion of gas connection. Refer to ‘GasConnection’ section.Optional Accessories (Refer to Replacement Parts List) Rear Roller Kit. For installation details, refer to instructions supplied with each kit. Plinth Kit. For installation details, refer to instructions supplied with each kit.1. Check all feet (or castors) are securely fitted.2. Adjust feet to make oven range steady and level.Gas ConnectionNOTE: ALL GAS FITTING MUST ONLY BE CARRIED OUT BY AN AUTHORISED PERSON.1. Waldorf Ranges do not require an electrical connection, as they function totally on gas supply only.2. It is essential that gas supply is correct for appliance being installed and that adequate supplypressure and volume are available. The following checks should be made before installation:-a. Gas Type the appliance has been supplied for is shown oncoloured stickers located above gas connection and onrating plate. Check that this is correct for the gas supplythe appliance is being installed for. Gas conversionprocedure is shown in this manual.b. Supply Pressure required for this appliance is shown in‘Specifications’ section of this manual. Check gas supply toensure adequate supply pressure exists.c. Input Rate of this appliance is shown on Rating Plate andin ‘Specifications’ section of this manual. Input rate shouldbe checked against available gas supply line capacity.Particular note should be taken if appliance is beingadded to an existing installation.NOTE: It is important that adequately sized piping runs directly to connection joint on appliancewith as few tees and elbows as possible to give maximum supply volume.3. Fit gas regulator supplied, into gas supply line as close to appliance as possible.Fig 1Rating PlateLocation This appliance is for professional use and is only to be used by qualifiedpersons. Only authorised service persons are to carry out installation, servicing or gasconversion operations.CautionCombustible Surface Non Combustible SurfaceLeft / Right hand side 250mm (*) 0mmRear 50mm 0mm