Waldorf RN8410G Installation And Operation Manual

Also see for RN8410G: Installation and operation manual Installation and operation manual

Waldorf RN8410G Installation And Operation Manual Manual pdf 22 page image

20Gas Conversion and SpecificationsGriddle1. Carry out the following:- Remove griddle plate section and heat shield. Remove main burner. Disconnect piezo igniter from mountingbracket. (For access purposes). Disconnect pilot supply tube from pilot burnerto access pilot injector.2. With Main Burner removed, ensure aeration gap is adjustedfor type of gas being used as shown in ‘Gas SpecificationsTables’ at end of this section.3. Remove pilot and main injectors and replace with correct sizeinjectors as shown in ‘Gas Specifications Tables’ at rear of thissection.4. Refit the following:- Re-connect pilot supply tube to pilot burner. Re-connect piezo igniter to mounting bracket. Refit main burner, gas control heat shield and griddle plate to cooktop.5. Re-light main burners and check flame size on ‘Low’ flame position. Adjust low fire adjustment screw on open burner gas controlvalves to obtain desired flame size.NOTE: The 'Low Fire Screw' should be sealed with coloured paint oncompletion of low fire adjustment.Static Oven1. Carry out the following:- Remove lower lintel at front of oven. Open oven door and remove sole plate(s). Remove main burner. Disconnect pilot supply tube from pilot burnerto access pilot injector.2. With Main Burner removed, ensure aeration gap is adjustedfor type of gas being used as shown in ‘Gas SpecificationsTables’ at rear of this section.Main Burner InjectorPilot SupplyTubePilot BurnerPiezo IgniterLow Fire ScrewBurner Adjustment ScrewAeration SlideBurner Adjustment ScrewMain BurnerMain Burner InjectorPilot BurnerThermocoupleAeration Slide