4SpecificationsGas Supply Requirements- Australia- New Zealand:- United Kingdom:Category: II2H3P (20, 37).Flue Type: A1.* Measure burner operating pressure at manifold test point with two burners operating at fullsetting. Operating pressure is ex-factory set, through appliance regulator and is not to beadjusted, apart from when converting between gases, if required. (Refer to ‘Gas Conversion’section for details).Natural Gas (G20) Propane (G31)Open Burner(each)Griddle(each 300mm section) Oven Open Burner(each)Griddle(each 300mm section) OvenHeat Input(nett)Nominal 6.5 kW 5.5 kW 6.5 kW 6.5 kW 5.5 kW 6.0 kWReduced 1.75 kW 1.85 kW 1.1 kW 1.75 kW 1.95 kW 1.05 kWGas Rate(nett)Nominal 0.69 m3/hr 0.58 m 3/hr 0.69 m3/hr 0.51 kg/hr 0.43 kg/hr 0.47 kg/hrReduced 0.19 m3/hr 0.20 m 3/hr 0.12 m3/hr 0.14 kg/hr 0.15 kg/hr 0.09 kg/hrSupply Pressure 20 mbar 30 / 37 mbarBurner OperatingPressure (*) 9.5 mbar (*) 26 mbar (*)Gas Connection 3 /4 ” B.S.P. MalePilot 200W 170W 170W 200W 150W 150WPilot 0.02 m3/hr 0.02 m 3/hr 0.02 m3/hr 0.02 kg/hr 0.01 kg/hr 0.01 kg/hrNatural Gas LP Gas (Propane)Input Rate (N.H.G.C.)- each Open Burner 28 MJ/hr 28 MJ/hr- each 300 mm Griddle Section 21 MJ/hr 21 MJ/hr- Oven 24 MJ/hr 24 MJ/hrSupply Pressure 1.13 - 3.40 kPa 2.75 - 4.50 kPaBurner Operating Pressure (*) 0.95 kPa (*) 2.6 kPa (*)Gas Connection 3 / 4 ” B.S.P. MaleNatural Gas LP GasInput Rate (N.H.G.C.)- each Open Burner 28 MJ/hr 28 MJ/hr- each 300 mm Griddle Section 21 MJ/hr 21 MJ/hr- Oven 24 MJ/hr 24 MJ/hrSupply Pressure 1.13 - 3.40 kPa 2.75 - 4.50 kPaBurner Operating Pressure (*) 0.95 kPa (*) 2.6 kPa (*)Gas Connection 3 / 4 ” B.S.P. Male