Walker H27i Operator's Manual

Also see for H27i: Operator's manual Operator's manual

Safety Instructions16SAFETY, CONTROL, AND INSTRUCTION DECALSSafety, Control, and Instruction Decals are installed on the machine;if any are missing, illegible, or damaged, a replacement should be ordered and installed beforeputting the machine into operation. The Decal Part Number is listed below and in the Parts Manual.Location: Right FenderPart Number: 2802-41. Warning – do not operate the machine without adeck or other implement attached.2. Forward Speed Control● Move lever forward to increase speed; backto stop.3. Body Tilt Latch● Raise lever to release.● Lift at back of body to raise.4. Warning – do not engage PTO clutch with PTOshaft disconnected.5. PTO Clutch Lever● Move lever forward to engage PTO clutch;back to disengage.2.3.4.51.1. Warning – rollover/crushing hazard.● Do not operate the machine on steep slopesor near dropoffs.● Avoid quick and/or sharp turns when operating on slopes.2. During normal operation always keep the ROPSlocked fully upright and use the seat belt.3. Never use the seat belt if the ROPS is not lockedfully upright.4. Do not operate the machine on slopes if theROPS is not locked fully upright.5. Do not remove the ROPS.Location: ROPS Roll Bar (If Equipped)Part Number: 5685-32.3.1.4.5.5685-3