8ASSEMBLY OF BATCH BOWL PARTSPrior to First Use:• Clean and sanitize the motor base. Wash, rinse, and sanitizethe batch bowl, cover, food pusher, small pusher insert andaccessories.• Place base on a counter or table near a 3-prong electricaloutlet. Position it so you look at the front of the unit and can seethe control panel. Do not plug in the cord until the processor iscompletely assembled.• Pick up the transparent batch bowl, holding it in both handswith the handle toward you.• Place the bowl on the base, fitting its central tube over themotor shaft on the base and placing its handle slightly to theleft of back-center (at about a 7 o’clock position).• Press the bowl down so the lower rim fits around the circularplatform. Turn the bowl counterclockwise as far as it will go. Itwill lock into position with the tabs on the sides of theplatform.Read this if assembling the batch bowl parts to use S-bladeor whipping disc assembly.• Pick up the S-blade or whipping disc, noting the diagram onthe top of the plastic center. It matches the shape of the motorshaft.• Place the S-blade or whipping disc over the top of the motorshaft, lining up the inside of the hub with the shaft. Press itdown firmly, rotating the center hub until the blade or discassembly is fully seated. It should easily drop into place. Pushfirmly to lock and seal S-blade or whipping disc hub in place.Be sure it is pushed down as far as it will go. If it is not all theway down, it may become damaged and any liquid may leak.Push only on the center section (plastic part); never touch thecutting blade, as it is extremely sharp.• Check to be sure the blade or disc is all the way down byturning it back and forth while gently pushing it down. Ifproperly installed and fully seated, the lower blade will bepositioned just above the inside bottom of the bowl.• If processing food with the S-blade or whipping disc, now is thetime to add the food or liquid to the batch bowl.