Watchguard Firebox V10 Installation Manual

Also see for Firebox V10: Hardware guide Quick start guide Supplementary guide End user guide Hardware guide

Contents

Watchguard Firebox V10 Installation Manual Manual pdf 51 page image

Installing the Vcontroller (Linux)Installation Guide 35N OTEYou must activate your LiveSecurity Service to enable VPN 3DESencryption or receive WatchGuard Support. To activate your LiveSecurityService, go to:http:\\www.watchguard.com\activateFor more information on LiveSecurity Service, see thePolicyConfiguration Guide, Chapter 2, Service and Support.You can now turn to for step-by-step guidance through the process ofdiscovering your new Firebox Vclass appliance via the network. Once theappliance has been discovered, you can immediately begin the initialsoftware configuration, as detailed in the following chapter.N OTEIf you want others to have access to this new appliance for administrativeor monitoring purposes, you can allow them to install the Vcontrollersoftware onto their workstations. Prior to their using the Vcontroller,you, as the System Administrator, should first configure the appliance,then use the Vcontroller Account Manager window to set up accessprivileges and accounts for each additional user. These configuration andaccess management processes are fully detailed in theSystemAdministration Guide.Installing the Vcontroller (Linux)Before proceeding with the following, make sure you have all of thenetwork addressing information that will represent the Firebox Vclasssecurity appliance, including the IP address and accompanying subnetmask that will replace the default addressing assigned to each of the dataports of the appliance–0 (Private), 1 (Public) and 2 (DMZ) interfaces(where available).N OTEBE SURE TO REVIEW the release notes that were included in thispackage for information about Linux-Java issues that you should be aware1install_guide.book Page 35 Friday, June 7, 2002 1:10 PM