Watchguard Firebox V10 Installation Manual

Also see for Firebox V10: Hardware guide Quick start guide Supplementary guide End user guide Hardware guide

Contents

Watchguard Firebox V10 Installation Manual Manual pdf 72 page image

CHAPTER 4: Completing the Vcontroller Installation Wizard56 Vcontroller 3.22 Click in the Network Mask field and type the correct entry.N OTEIf a 3 interface (DMZ2) is available, it cannot be put to use at this time.Completing the Wizard Interface tab entriesTo save your new Interface tab entries (no matter which model ofappliance you are configuring), follow these steps:1 When you have finished with the Interface tab entries, click Next toproceed.An informational dialog box appears, providing two options:- Save Only (not recommended)- Apply (recommended)2 If Save Only is selected, click OK to proceed.N OTEYou should click Apply and then click OK if you want to continue to usethe Wizard after saving the newly configured interface addresses.1install_guide.book Page 56 Friday, June 7, 2002 1:10 PM