Wood Stone BISTRO 3030 Installation And Operation Manual

Also see for BISTRO 3030: Installation and operation manual Installation and operation manual Installation and operation manual Installation and operation manual Installation and operation manual

OVEN INTERIORWood Stone recommends the use of long-handled brushes for sweeping up surface debris that will accumulate on the floor of theoven during use� Use a natural fiber brush—always brushing away from the radiant burner well� For deeper cleaning, use a brassbristled brush� The oven floor can be then cleaned with a damp rag wrapped around the brass bristled brush head� (Wood Stoneoffers an assortment of oven brushes available through your dealer� Specification sheets may be viewed on the Wood Stone websiteunder Tools & Accessories�)DO NOT POUR OR SPRAY LIQUIDS ONTO THE OVEN DECK OR INTO THE OVEN INTERIOR AS THIS CAN DAMAGE THECERAMIC AND WILL VOID THE WARRANTY.DO NOT USE THE RADIANT BURNER WELL AS A DUMP FOR DEBRIS OR TRASH INCINERATION; MAKE EVERYATTEMPT TO KEEP DEBRIS FROM DROPPING INTO THE WELL.There is a stainless steel burner guard to prevent food from falling on and thereby obstructing the gas orifices of the radiant flame�If food gets into the radiant flame well and the flame is visibly obstructed, turn the oven off immediately, and call forservice�OVEN EXTERIORAll painted and stainless steel surfaces should be cleaned as necessary using an approved mild detergent, hot water and a soft clothor sponge� Stubborn residues may be removed using a nonmetallic scouring pad� When scouring stainless steel surfaces, scrubwith the grain of the metal to prevent scratching�IMPORTANT: DO NOT USE EXCESSIVE AMOUNTS OF LIQUID WHENWIPING ON OR AROUND THE CONTROL BOX.GAS-FIRED OVEN THERMAL CLEANINGIf a Wood Stone gas-fired oven is operated at low temperatures below 274 °C (525 °F), you may notice a buildup on the oven floor�If you operate the oven below 232 °C (450 °F), you may also notice some buildup on the interior walls and/or ceiling of the oven� Toremove any buildup that has accumulated inside of the oven, simply turn the radiant flame to its highest setting� Monitor the hearthfloor temperature displayed on the controller� When the floor reaches 343 °C (650 °F), lower the flame slightly so as to maintain theoven floor temperature near 343 °C (650 °F) for about an hour� Heavy accumulations may require more time� Heavy accumulationson the floor may require some additional scraping with a utility peel or a floor scraping tool� Once the oven appears clean, allow theoven to return to normal operating temperatures and continue normal operation�Never use any type of chemical cleaner on the oven ceramic� This will damage the oven an void the warranty�BURNER TRAYAt 6–12 month intervals, depending on the amount of usage, the burner tray beneath the oven should be removed andemptied of any accumulated debris� To remove: unscrew the wing nut at the back of the burner tray� See location in theEXPLODED PARTS DIAGRAM section� There should be very little debris in the tray if the oven is being operated properly�28An ongoing program of product improvement may require us to changespecifications without notice. BL-RFG-CE, BL-RFG-W-CE,Revised February 2015. Doc no: M0027.02info@woodstone-corp.com or visit woodstone-corp.comwood stone corporation1801 w. bakerview rd.bellingham, wa 98226 usat. +1.360.650.1111f. +1.360.650.1166Bistro CE Installation and Operation ManualDAILY MAINTENANCE