XP PLS600 Series User Manual
Also see for PLS600 Series: Programming manual
                                           | |
Contents
| 
12Turn the Voltage control to adjust the OVP setting. When the desired setting is displayed press the output on/off button and thesupply will revert to its previous state.To adjust OCP press and release the Current control. The following screen will appear:Turn the Current control to adjust the OCP setting. When the desired setting is displayed press the output on/off button and thesupply will revert to its previous state.If, during operation, any of these set points is exceeded the appropriate screen will be displayed as below.Pressing Output On/Off when any of the trip screens are displayed will reset the trip and put the power supply back in idlemode. The following screen will be displayed.Pressing Enable at this time will turn on the output.OcP setOcP = 2.500Overvoltage tripEnable to resetSystem set upmodeOvercurrent tripEnable to resetOverpower tripEnable to resetOff IocV=100.0 i=3.5007.2 Power Supply Setup7.2.1 IntroductionSetup mode allows configuration of the power supply. Within setup one can adjust the power on state, select I/O options,enable remote sense, and calibrate the power supply. To enter setup mode press and hold the output on/off button for at least 5seconds. When enabled the initial setup screen will appear |
Related manuals for XP PLS600 Series
This manual is suitable for:
manualsdatabase
Your AI-powered manual search engine