XVision XPR8/16P User Manual

Contents

XVision XPR8/16P User Manual Manual pdf 45 page image

DVR User’s Manual444.4.2.3 Export Event VideoTo export event video, follow these steps:• Press SEARCH and play wanted event video. To play event video, refer toOSD Setup Manual Section Search Recorded Video.• After entering the playback mode, press COPY. The “ezBurn” window willdisplay as below figure. The information shown on it is read only.• Press ENTER to start the export the whole event video to the connecteddevice; or, press ESC to abort.ezBurn confirmationSelected Device: Built-in DVD+RWAll data on the disc will be erased.Exported Required Size = 11 MBExport Event Info:Data Time Ch Type2008/05/07 AM10:42:35 13 MotionEnter: Yes ESC: No• If there is no exportable device connected to the DVR, then a warningmessage will be shown on the screen.4.5 Dome ControlThe DVR allows user to control a dome camera by the front panel. In Livemode, user can press CHANNEL key to display the desired dome camera infull screen. To enter dome control mode, press the DOME key and presschannel key 2 to display the hint screen. To exit the dome control mode andreturn to live mode, press ESC or DOME.In dome control mode, press CALL + ENTER to open the OSD setup menu ofthe dome camera. To traverse the menu, press CALL + UP/DOWN keys tomove up/down, CALL + RIGHT/LEFT to change value or to move left/right,and CALL + ENTER to select or enter submenu.4.5.1 Dome ConnectionFollow the steps to install dome camera.• See Setup Guide for RS-485 port pin definition.• Connect the R+, R- terminals on the dome camera to the D+, D− terminalson the RS-485 port by RS-485 cable respectively. Refer to the connectionfigure illustrated in Setup Guide.