Xerox 4110 Configuration And Setup

Also see for Fiery EXP4110: Guide for Operators Customer release notes Print Options Printing guide

Contents

Xerox 4110 Configuration And Setup Manual pdf 39 page image

S ETTING UP THE F IERY EXP4110 FROM THE C ONTROL P ANEL 39IPX/SPX Setup optionsTo specify the frame types the Fiery EXP4110 uses for IPX/SPX protocols, choose IPX/SPXSetup from the Protocol Setup menu. You must choose at least one frame type to enable IPX/SPX protocols. The Fiery EXP4110 supports the following frame types for IPX/SPX:Ethernet 802.2, Ethernet 802.3, Ethernet II, and Ethernet SNAPFor protocols other than IPX/SPX, the frame type is automatically enabled and does notrequire setup, as follows:Select Frame TypesEnable IPX Auto Frame TypeYes/No [No]Specify whether the Fiery EXP4110 should try to bind to all available frame typesautomatically. The Fiery EXP4110 does so whether or not all frame types are appropriate.To determine whether any frame types were successfully bound, save your changes, exit Setup,restart the Fiery EXP4110, and print a Configuration page. The Configuration page lists onlyone of the frame types that were successfully bound.If you answer No to this option, you can select frame types manually. You must choose at leastone frame type to enable IPX/SPX protocols.Select each frame type used on your IPX/SPX network. An asterisk (*) appears beside eachselected frame type. Press the line selection button again to cancel a selected frame type. Usethe up and down arrow buttons to scroll to additional frame types. The Fiery EXP4110 bindsto each frame type as you select it.When you have selected all the frame types used, choose Exit IPX/SPX Setup.Clear Frame TypesYou can clear all frame types at once by choosing Exit IPX/SPX Setup, choosing IPX/SPXSetup, and then choosing Clear Frame Types.Service Setup optionsPServer is a program in the Fiery EXP4110 software that services the Novell print queuesassigned to the Novell print servers set up for printing to the Fiery EXP4110. When youchoose PServer Setup and enable PServer, you can set up NDS (Novell Directory Services),Bindery Services, or both. NDS is used with NetWare; Bindery Services are used withNetWare in bindery emulation mode.With this protocol And these printing services This frame type isautomatically enabledAppleTalk PAP (Printer Access Protocol) Ethernet SNAPTCP/IP with Ethernet LPD (Line Printer Daemon) Ethernet II