Changing Output Roll Media for an Entire JobBy setting the [Output Option] [Size] selection to [AUTO], the output media isdetermined by the settings in the logical printer's [Media mapping] table. If a mediamapping table is prepared for each job, the output roll media can be changed for eachjob.For example, if an A1 roll and an A2 roll are loaded in the machine, and the A2 roll is tobe used for printing the A2 size (Job1) job, and the A1 roll media to be used for printing(Job2), which is also in A2 size, the mapping table is set up as follows.In this example, (Job1) is specified to use logical printer [PLT01H], which will outputthe job on the A2 roll media.(Job2) is specified to use logical printer [PLT02H] and rotate the job 90 degrees to printon the A1 roll media.[PLT02H] logical printer settings[PLT01H] logical printer settingsImage Size Media SizeA0 A0A1 A1A2 A1A3 A3A4 A3Image Size Media SizeA0 A0A1 A1A2 A2A3 A3A4 A4Job2Job1 A2A2Logical printer[PLT01H] specifiedLogical printer[PLT02H] specifiedRotated by90 degreesOutput on theA2 roll mediaOutput on theA1 roll media
