Message ListThis section explains messages that may be displayed during printing using theftp command.Status: Cannot establish connection for data transfer.Action: Wait a few moments and try again.Status: Cannot create a control file using the STOR command.Action: Wait a few moments and try again.Status: Cannot create a job file using the LJ command.Action: Wait a few moments and try again.Status: Cannot create a socket in passive mode.Action: Wait a few moments and try again.Status: Cannot open a parameter file for creating the specified file.Action: Wait a few moments and try again.Status: Command (XX) received not supported.Action: Enter the correct command.Status: A control connection error occurred in the FTP command wait status.Therefore, the connection was disconnected.Action: For another transfer, establish the connection again.Can't build data connectionCan't create control file, please try laterCan't create status file, please try laterCan't open passive connectionCannot create file "xx" or permission problemCommand "xx" not understoodControl connection read error
