MacintoshWorkCentre® C2424 Copier-Printer6-355. Select your system from the list provided.6. Select the appropriate PPD from the list in the Printer Model drop-down list. If yoursystem PPD is not listed, install it from the WorkCentre C2424 Software CD-ROM.7. Click Add to complete the configuration.For more information, go to the table of infoSMART Knowledge Base documents at the end ofthis section.Creating a Rendezvous System with Mac OS X, Version 10.2 and Higher1. Open the Print Center utility. In Mac OS X, version 10.3 or higher, the utility is calledPrinter Setup. The utility is located in Utilities in the Applications directory.2. Click Add.A list appears displaying name of your system, followed by a series of numbers. Forexample, Your System’s Name xx:xx:xx. Each numbered segment represents the lastsection of your system’s hardware address. Your PPD is automatically selected.3. Click Add to complete the installation.Macintosh Troubleshooting (Mac OS 9.x, Mac OS X, Version10.1 and Higher)The following procedure eliminates cabling, communication, and connection problems. Onceyou complete these steps, print a test page from your software application. If the job prints, nofurther system troubleshooting is necessary. If there are print quality problems, see theTroubleshooting section of this guide.Macintosh Troubleshooting Step-By-StepMac OS 9.xPerform these steps only for Mac OS 9:1. Open the Chooser, then click the LaserWriter driver.2. Do one of the following:■ If the system’s name appears, your device is communicating through the network. Youdo not need to perform any additional steps.■ If the system’s name does not appear, proceed to Step 3.3. Verify that the system is plugged in, turned On, and connected to an active network.4. Verify the cable connection from the network to the copier-printer system.5. Follow these steps:a. From the system’s control panel, verify that EtherTalk is enabled. If it is not, enable itin the control panel, then reset the system.b. Print the “Configuration Page” and verify that EtherTalk is enabled.c. From the “Configuration Page”, verify the Zone. If you have multiple zones on yournetwork, verify that your copier-printer system appears in the desired zone.
