System SettingsWorkCentre® C2424 Copier-Printer1-15Using CentreWare ISTo turn on/off the automatic printing of the “Startup Page”:1. Launch your web browser.2. Enter your system’s IP address in the browser’s Address field (http://xxx.xxx.xxx.xxx).3. Select Properties.4. Click the General folder on the left sidebar, then click Printer Defaults.5. Under User Preferences, select Off or On from the Startup Page drop-down list tochange the setting.6. Click Save Changes at the bottom of the page.Printing the Startup PageTo print the “Startup Page”:1. On the control panel, press the System Setup button.2. In the menu, select Information, then press the Enter button.3. Select Information Pages, then press the Enter button.4. Select Startup Page, then press the Enter button to print.NoteYou can also print the Startup Page from the Troubleshooting tab of the Windows printerdriver.Changing the Power Saver TimeoutTo save energy, the system enters a Power Saver, low-energy consumption mode after a pre-defined period of time since its last activity. In this mode, most electrical systems are shutdown. When a print job is sent to the system, the system enters Warmup Mode. You can alsowarm up the system by pressing the Enter button on the control panel.NoteWhen the system enters Power Saver mode, you will hear the printhead moving. This ispart of the normal system operation.If you find that the system is going into Power Saver mode too often and you do not want towait while the system warms up, increase the length of time before the system goes into PowerSaver mode.To change the Power Saver timeout value, use either:■ The control panel■ CentreWare ISUsing the Control Panel1. On the control panel, press the System Setup button.2. In the menu, select General Setup, then press the Enter button.
