Xerox ® DocuMate® 5445 / 5460User’s Guide190Checking the Scanner Firmware VersionYou will need to know the scanner’s firmware version to determine which features are available in the hardware.Change to the Advanced source configuration mode. Go to the Driver Configuration section and then click on thescanner tab. The scanner’s firmware version is displayed on the left side of this tab.Note that the scanner’s maximum page length varies by scan resolution for some scanners. Please refer to theinformation below for your scanner model to determine supported page sizes and hardware features.Xerox DocuMate 5445 / Xerox DocuMate 5460 — firmware version lower than 2.0• Maximum page length for all resolutions: 100 inches (2540 mm)If this is your scanner version, please continue to the Scanning section of this chapter.Xerox DocuMate 5445 / Xerox DocuMate 5460 — firmware version 2.0 or higher• Maximum page length varies by resolutionIf this is your scanner version, please continue to Hardware Image Processing for Your Scanner.Resolution Xerox DocuMate 5445 Xerox DocuMate 546075 dpi* 150 inches (3810 mm) 195 inches (4953 mm)100 dpi 150 inches (3810 mm) 195 inches (4953 mm)150 dpi 150 inches (3810 mm) 195 inches (4953 mm)200 dpi 150 inches (3810 mm) 195 inches (4953 mm)300 dpi 150 inches (3810 mm) 195 inches (4953 mm)400 dpi 150 inches (3810 mm) 150 inches (3810 mm)500 dpi 120 inches (3048 mm) 120 inches (3048 mm)600 dpi 100 inches (2540 mm) 100 inches (2540 mm)1200 dpi* 100 inches (2540 mm) 100 inches (2540 mm)*this is an interpolated resolution which is available withsoftware Visioneer Acuity only.
