5.5 < Loading print media>Using tray 1 or the optional tray 2Use the print material you use for the majority of your print jobs in tray 1.Tray 1 can hold a maximum of 250 sheets of 75 g/m 2 paper.You can purchase an optional tray 2 and attach it below tray 1 to load anadditional 250 sheets of paper.To load paper, pull open the tray and load paper with the side to beprinted on face down.You can load letterhead paper with the design side face down. The topedge of the sheet with the logo should be placed at the front of the tray.Notes• If you experience problems with paper feed, place one sheetat a time in the manual feed.• You can load previously printed paper. The printed sideshould be facing up with an uncurled edge at the front. If youexperience problems with paper feed, turn the paper around.Note that the print quality is not guaranteed.Changing the size of the paper in tray 1To load longer sizes of paper, such as Legal-sized paper, you need toadjust the paper guides to extend the paper tray.3250-0303250-0423 1241 paper length guide2 support guide3 guide lock4 paper width guides1 Press and hold the guide lock, and slide the paper length guide tolocate it in the correct paper size slot.2 After inserting paper into the tray, adjust the support guide so that itlightly touches the paper stack.3 Squeeze the paper width guides, as shown and slide them to thestack of paper until they lightly touch the side of the stack.3250-0273250-0283250-029
