Service Parts DisassemblyPhaser 3320 and WorkCentre 3315/3325 Xerox Internal Use OnlyService Manual4-2OverviewThis section contains the removal procedures for field-replaceable parts listed in the Parts List. In mostcases, the replacement procedure is simply the reverse of the removal procedure. In some instances,additional steps are necessary and are provided for replacement of the parts. For specific assembliesand parts, refer to Chapter 9.Standard Orientation of the PrinterWhen needed, printer orientation is called out in the procedure as an aid for locating the printer parts.The following figure identifies the Front, Rear, Left, and Right sides of the printer.PreparationBefore you begin any procedure:WARNING: Allow the Fuser to cool before using the procedure.CAUTION: Many parts are secured by plastic tabs. Do not over flex or force these parts. Do notover torque screws threaded into plastic.Note: Names of parts that appear in the removal procedures may not match the names thatappear in the Parts List. For example, a part called Paper Tray in a removal procedure may appearon the Parts List as Cassette, Assy. While using removal procedure, ignore any prerequisiteprocedures for parts already removed.1. Wear an Electrostatic Discharge wrist strap.2. Turn Off power and disconnect the power cord from the wall outlet.3. Disconnect all cables from the printer.4. Remove the Print Cartridge (page 4-5).s3320-252FrontRearLeftRight
