Loading PaperXerox Phaser 3320DN/3320DNIUser Guide672. Slide the paper length guide until it lightly touches theend of the paper stack.3. Position the side guide by squeezing the lever and slidingit towards the stack of paper, until it gently touches theside of the stack.4. Insert the paper tray into the machine.5. After loading paper in the paper tray, set the paper sizeand type using the control panel. For information aboutsetting the paper size and type on the control panel, referto Setting Paper Size and Type on page 70.6. When printing from your computer, ensure you selectSize on the driver Paper tab to specify the correct papersize and type. Not confirming the paper details mayresult in printing delays. For information about settingthe paper size and type in the printer driver, refer to Paper Tab on page 38.Note: The settings made from the printer driver on your computer override the settings on thecontrol panel.Using the Bypass TrayThe bypass tray is located on the front of your machine. It can be closed when not in use, making theproduct more compact. Use the bypass tray to print transparencies, labels, envelopes or postcards inaddition to making quick runs of paper types or sizes that are not currently loaded in the paper tray.When using the bypass tray for special media it may be necessary to use the rear door for the output.For further information refer to Media Output Locations on page 18.Note: The rear door output can only be used for simplex jobs. Duplex printing with the rear dooropen will cause paper jams.Acceptable print media is plain paper from 3.0 x 5.0 inches to 8.5 x 14 inches Legal (76 mm x 127 mmto 216 mm x 356 mm) and weighing between 16 lb and 58 lb (60 g/m² and 220 g/m²). For more mediaspecifications, refer to Media Guidelines and Specifications on page 71 and Media Specifications onpage 119.
