Troubleshooting144 Phaser 6600 Color PrinterUser GuideProbable Causes SolutionsThe printer is busy. • If the Ready Indicator is flashing, it is normal. A previous printjob could be the problem. Use the printer properties to deleteall print jobs in the print queue.• Load the paper in the tray.• If the Ready Indicator is not flashing after you send a print job,check the USB connection between the printer and thecomputer. Turn off the printer, then turn it on again.The printer cable is disconnected. • If the Ready Indicator is not flashing after you send a print job,check the USB connection between the printer and thecomputer.• If the Ready Indicator is not flashing after you send a print job,check the Ethernet connection between the printer and thecomputer.Printing Takes Too LongProbable Causes SolutionsThe printer is set to a slower printing mode,for example, for printing on glossy orheavyweight paper.It takes more time to print on certain types of special paper.Ensure that the paper type is set properly in the driver and at theprinter control panel. For details, see Print Speed on page 176.The printer is in Energy Saver mode. Wait. It takes time for printing to start when the printer is comingout of Energy Saver mode.The way the printer was installed on thenetwork could be an issue.Determine if a print spooler or a computer sharing the printer isbuffering all print jobs and then spooling them to the printer.Spooling can slow print speeds. To test the speed of the printer,print some information pages such as the Office Demo Page. Ifthe page does not print at the rated speed of the printer, youcould have a network or printer installation issue.The job is complex. Wait. No action needed.The print-quality mode in the driver is set toEnhanced.Change the print-quality mode in the print driver to Standard.The printer quality is set to Photo and theprinter is being used for complex, 2-sidedprint jobs.Increase memory size to 768 MB RAM by installing theProductivity Kit (Memory).
