Xerox WNA-100 User Manual
Also see for WNA-100 - Bridge: Setup and configuration guideInstallation guideSpecificationsSpecifications
                         | |
Contents
|
Xerox WNA-100 Wireless Network AdapterB-1Xerox has tested this product to electromagnetic emission and immunity standards. Thesestandards are designed to mitigate interference caused or received by this product in a typicaloffice environment.Information for United States UsersThis equipment has been tested and found to comply within the limits for Class B digitaldevice pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonableprotection against harmful interference in a residential installation. This equipment generates,uses, and can radiate radio frequency energy and, if not installed and used in accordance withthe instructions, may cause harmful interference to radio communications. However, there isno guarantee that interference will not occur in a particular installation. If this equipment doescause harmful interference to radio and television reception, which can be determined byturning the equipment off and on, the user is encouraged to try to correct the interference byone or more of the following measures:■ Reorient or relocate the receiving antenna.■ Increase the separation between the equipment and receiver.■ Connect the equipment into an outlet on a circuit different from that to which the receiveris connected.■ Consult the dealer or an experienced radio/TV technician for help.The user is cautioned that changes and modifications made to the equipment without theapproval of manufacturer could void the user’s authority to operate this equipment.Operation is subject to the following two conditions:1. This device may not cause harmful interference.2. This device must accept any interference received, including interference that may causeundesired operation.The radiated output power of the print server is far below the FCC radio frequency exposurelimits. Nevertheless, the print server shall be used in such a manner that the potential forhuman contact during normal operation is minimized.To satisfy RF exposure requirements, this device and its antennas must operate with theseparation distance of at least 20 centimeters from all persons and must not be co-located oroperating in conjunction with any other antenna or transmitter. End users must be providedwith specific operating instructions for satisfying RF exposure compliance.Security andRegulations |
Related manuals for Xerox WNA-100 - Bridge
This manual is suitable for:
manualsdatabase
Your AI-powered manual search engine