Xerox WORKCENTRE 3119 Service Manual

Also see for WorkCentre 3119: User guide Service manual

Contents

Xerox WORKCENTRE 3119 Service Manual Manual pdf 136 page image

General Procedures and Information6-26 06/06 WorkCentre 3119one of pre-defined times as power save time from the Driver UI. The setting value for power savetime is OFF, 5min, 10min, 15min, 30min, 45min, and 60min. The default time is 5min. If OFF isselected, power save time is operated after 2 hours to protect the fuser.Functional Requirements of Toner CartridgeInstallation Toner CartridgeThe WorkCentre 3119 main firmware checks the validity and status of the CRUM on the toner car-tridge. The crum stores the ID, the opc cycle, the toner consumption and so on.Toner SaveThis function is to reduce toner consumption. There are 3 different methods used on this printerto do so:• Modulating the video data• Modulating the DEV voltage in the engine firmware.• Controlling the power of the laser diode.Functional Requirements of OPC DrumClean OPC DrumTo clean the contamination of the OPC drum, all remaining toner should be removed.Manual: This function can be used by the user at anytime. When the user selects this function, theengine receives the OPC cleaning command from the main system and performs the cleaning op-eration. There are two methods to clean the OPC. One is the minus clean mode, and the other isthe plus clean mode.Minus clean mode: Supplying negative voltage to the transfer roller to remove toner with a nega-tive charge.Plus clean mode: Supplying positive voltage to the transfer roller to remove toner with a positivecharge. The developer team presents the cleaning process.Functional Requirements of Fan OperationThe fan is always in operation except during sleep mode. When the engine encounters an error,the engine stops the fan. However, when the engine enters sleep mode, the engine stops the fanafter 5 minutes due to toner fusing. The Fan operates during warm up and print.Door OpenWhen the cover is open, the engine stops all functions. It sends an error message to the main sys-tem and an error message is displayed on the LCD. If the cover is closed, the engine operates thewarm-up process.No paperWhen the paper cassette is empty, the engine notifes the printer system. Then, an error messageis displayed on the LCD. When the user loads paper in the cassette, the error is removed.