Image QualityWorkCentre 3119 06/06 3-7IQ 5 Light ImageDescriptionThe printed image is light, with no ghost.Check and Cause Solution1. Toner Save mode enabled. 1. Ensure the Toner Save mode isoff, GP 3. Check printer and driversettings.2. Check shading profile in TechMode, GP 5.2. Redo shading profile in the Techmode, GP 5.3. Bad contact caused by dirty con-tacts on the toner cartridge.3. Clean the following parts:• Toner cartridge contacts, PL 1• MEC-TERMINAL, PL 3• IPR-P-Terminal CON, PL 3Clean all dirt from inside the frameassembly, PL 3.4. Ambient temperature is belowthan 10°C.4. Wait 30 minutes after the printerhas powered on before you startprinting.5. The toner is not properly distrib-uted in the cartridge.5. Remove the toner cartridge, PL1, gently shake it and replace.6. A ticking noise occurs. Measurethe time between ‘ticks’.6. If the ticks occur between 2 sec-ond intervals, the toner cartridge isalmost exhausted. Install a newtoner cartridge, PL 1.7. The toner cartridge life hasexpired.7. Install a new toner cartridge, PL1.8. Develop roller is contaminatedwhen the toner has almostdepleted.8. Install a new toner cartridge, PL1.9. Check the HVPS output usingEngine Test Mode, GP 4.9. If necessary, install a new SMPS/HVPS, PL 1.
