FaxingConfiguring Fax Settings from CentreWare Internet ServicesIf your printer is connected to your computer through a wired or wireless network connection, useCentreWare Internet Services to configure the fax settings.1. At your computer, open a Web browser, in the address field, type the IP address of the printer, thenpress Enter or Return.Note: If you do not know the IP address of your printer, see Finding the IP Address of Your Printer onpage 12.2. Click Properties > Fax > Fax Settings.3. The first time you set up the fax settings, under Country, specify the country where the printer islocated.4. Click Save Changes. Once the printer restarts, select the remaining options as needed.5. Configure Fax Line Settings:a. To specify the telephone number to appear at the top of each page sent from the printer, typea fax number.b. Update the country name where the printer is located as needed.c. Type the name of your company as needed.d. To specify the line type, select an option.e. For Line Monitor, specify the volume for the external telephone.f. To specify a distinctive ring pattern, for Distinctive Ring Pattern Detection (DRPD), select anoption. Your telephone company specifies the DRPD Patterns.g. To specify the threshold value for the external telephone, for Extel Hook Threshold, select anoption.6. In the Incoming Defaults section, enter information.a. To specify the Receive Mode, select an option.b. To specify the Ring Tone Volume, select an option.c. To specify how long the printer waits before answering an incoming call, for Auto Answerreceive mode, select an option.• TEL Mode: Automatic fax reception is turned Off. You can receive a fax by picking up thehandset of the external phone, then pressing the remote receive code. You can also setOnHook to On to start the Fax after you hear fax tones from the remote device.• FAX Mode: This mode sets the printer to receive faxes automatically.• TEL/FAX Mode: When the printer receives an incoming fax, the external telephone ringsfor the time specified by Auto Ans, then the printer automatically receives the fax. If theincoming data is not a fax, the printer beeps.• Ans/FAX Mode: The printer can share one telephone line with an answering machine. Inthis mode, the printer monitors the fax signal and picks up the line if there are fax tones. Ifthe phone communication in your country is serial, this mode is not available.• DRPD Mode: Before using the Distinctive Ring Pattern Detection (DRPD) option, distinctivering service must be installed on your telephone line by the telephone company. After thetelephone company provides a separate number with a distinctive ring pattern, configurethe fax setup to monitor for that specific ring pattern.104 Xerox ® WorkCentre® 3615 Black and White Multifunction PrinterSystem Administrator Guide
