3 Network Installation20 Xerox WorkCentre 4260 Series System Administration GuideDHCP/DDNS:• Release Registration – Allows DHCP resources to be released when the machine ispowering down. This is a display-only item and shows “Enabled”.Zero-Configuration Networking:• Self Assigned Address (IPv4) – Allocates an IPv4 address without using a DHCPserver. This check box is selected when [IP Address Resolution] is set to [Autonet].This is a display-only item.• Self Assigned Address (IPv6) – Displays “Enabled”. This is a display-only item.SNMP ConfigurationAllows you to configure the following options when accessing the machine via SNMP.SNMP Properties:Enable SNMP v1/v2c Protocols – Allows you to enable or disable the SNMP v1/v2c protocols.Edit SNMP v1/v2c Properties – Displays the page which allows you to set the following SNMPv1/v2c properties.Community Names:• Community Name (Read Only) – Enter the community name used for display.• Community Name (Read/Write) – Enter the community name used for display andupdate.Default Trap Community Name:• TRAP Community Name – Enter the trap notification community name.System Administrator’s Login ID:• System Administrator’s Login ID – Enter the ID of the System Administrator.Enable SNMP v3 Protocol – Allows you to enable or disable the SNMP v3protocol.Edit SNMP v3 Properties – Displays the page which allows you to set thefollowing SNMP v3 properties.This button is active only when the Secure HTTP (SSL) feature is enabled.Administrator Account:• Account Enabled – Select to enable the System Administrator’s account.• User Name – Displays the user name of the System Administrator.• Authentication Password (minimum 8 characters) – Enter the authenticationpassword using 8 to 32 characters.• Confirm Authentication Password – Re-enter the authentication password forverification.
