Installation and Setup42 WorkCentre 7220/7225 Multifunction PrinterUser GuideModifying General SettingsYou can modify printer settings such as the language, date and time, units of measurement, displaybrightness, and startup page from the control panel.1. At the printer control panel, press the Machine Status button, then touch the Tools tab.2. Touch Device Settings > General, then touch the setting you want to change:− Energy Saver specifies when the printer goes into energy-saving mode.− Date and Time allows you to set the time zone, date, time, and display format.− Language/Keyboard Selection allows you to set the language and keyboard layout.− Custom Keyboard Button allows you to assign text to the custom key on the virtual keyboard.Note: This is a partial list. If a feature does not appear, contact the system administrator or log in asa system administrator. For details, see Logging In as the System Administrator at the Control Panelon page 32.3. Touch Save.Setting Energy Saver ModeYou can set the time the printer spends idle in ready mode before the printer transitions to a lowerpower level.To configure Energy Saver settings:1. At the printer control panel, press the Machine Status button, then touch the Tools tab.2. Touch Device Settings > General > Energy Saver.Note: If this feature does not appear, log in as a system administrator. For details, see Logging In asthe System Administrator at the Control Panel on page 32.3. Under From Standby Mode to Energy Saver Mode, to set the time in minutes, touch the arrowbuttons. Standby Mode uses more energy, but wakes faster than Energy Saver Mode.4. Under From Energy Saver Mode to Sleep Mode, to set the time in minutes, touch the arrow buttons.Energy Saver Mode uses more energy, but wakes faster than Sleep Mode.5. Touch Save.
