28Customizing Your WorkCentreProgrammable FeaturesThe default settings for various machine features may be changed to suityour individual needs. All of these features remain set until this process isrepeated.Each of the programmable features, along with its program number andoptions are contained in the chart below. The procedure to change thedefault settings follows the chart.Note: The procedures written in this manual are based on the factorydefault settings.Feature ProgramNumberOption Number* Factory SettingPriority Tray: This feature allows youto set the default paper tray. At poweron or auto clear, the copier will returnto the selected priority paper tray.(Model XD104/105f/120f//130df/155dfonly.)0 0 – Main paper tray *1 – Alternate papertray2 - Second papertrayAuto Clear Time Out: This featureallows you to select the time it takesfor the copier to return to the normalcopy mode after a copy cycle iscomplete.1 0 – Off1 – 30 seconds2 – 60 seconds *3 – 90 seconds4 – 120 secondsTime Out to Power Save: Whenenabled, this feature automaticallyreduces power used by the copier ifthe copier has not been used for theset period of time.2 0 – Off1 – 45 seconds2 – 90 seconds *3 – 2 minutes4 – 5 minutesTime Out to Power Shut-Off: Whenenabled, this feature significantlyreduces power used by the copier ifthe copier has not been used for theset period of time.3 0 – 2 minutes1 – 5 minutes *2 – 15 minutes3 – 30 minutes4 – 60 minutes5 – 120 minutes6 – OffDefault Magnification: This featureallows you to make copies slightlylarger or smaller than the original, orthe same size.4 0 – 100% *1 – 99%2 – 101%