Safety notesXDL23/XDL33/XDL33D User Guide 1Safety notesYour copier and supplies meet strict safety requirements. These requirements include safetyagency examination and approval and compliance to any established environmental standards.Please read the following instructions carefully before operating the copier, and refer to theseinstructions, as required, in order to ensure the continued safe operation of your copier.Follow all the warnings and instructions which are marked on or supplied with the product.Unplug the copier from the wall outlet before cleaning it. Always use the materials which arespecifically designated for the copier. Use of any other materials may result in poor performanceand may create a hazardous situation.Do not use aerosol cleaners. Follow the instructions in this user guide for the proper cleaningmethods.Never use any supplies or cleaning materials for purposes other than what they are intended.Keep all supplies and materials out of the reach of children.Do not use the copier near water, wet locations, or outdoors.Do not place the copier on an unstable cart, stand, or table. The copier may fall, and therebycause personal injury or serious damage to the copier.This product is equipped with a three-wire, grounding-type plug (in other words, a plug having athird grounding pin). This plug fits into a grounding-type power outlet only. This is a safetyfeature. If you cannot insert the plug into the outlet, contact your electrician in order to replace thereceptacle; this ensures that you will avoid the risk of electric shock. Never use a ground adapterplug to connect the copier to a power source receptacle which lacks a ground connectionterminal.This copier should be operated from the type of power source which is indicated on the markinglabel. If you are uncertain as to the available power type, consult your local power company.Do not allow anything to rest on the power cord. Do not locate the copier where persons will stepon the cord.The power supply cord is the disconnect device for this equipment. Ensure that the installationof the copier is near the outlet and that the outlet is easily accessible.Your copier is equipped with an energy saving device which conserves power when the copier isnot in use. The copier may be left on continuously.Slots and openings in the copier cabinet provide ventilation; these slots and openings arelocated in the back and the sides of the copier cabinet. In order to ensure the reliable operation ofthe copier and to protect it from overheating, these openings must not be blocked or covered. Donot place the copier near or over a radiator or heat register. Do not place the copier in a built-ininstallation unless proper ventilation is provided.