Getting StartedXerox ® VersaLink ® C7020/C7025/C7030 Color Multifunction Printer 49User GuideConnecting to a Computer Using USB• Windows 7, Windows 8.1, Windows Server 2008, Windows 10, Windows Server 2008 R2, andWindows Server 2012.• Macintosh OS X version 10.10 and later.• UNIX and Linux: Your printer supports connection to various UNIX platforms through the networkinterface.To connect the printer to the computer using a USB cable:1. Connect the B end of a standard A/B USB 2.0 or USB 3.0 cable to the USB Port on the back of theprinter.2. Connect the A end of the USB cable to the USB port on the computer.3. If the Windows Found New Hardware Wizard appears, cancel it.4. Install the print driver.For more information, refer to Installing the Software on page 57.Connecting to a Wired Network1. Ensure that the printer is powered off.2. Attach a Category 5 or better Ethernet cable from the printer to the network or router socket.Use an Ethernet switch or router, and two or more Ethernet cables. Connect the computer to theswitch or router with one cable, then connect the printer to the switch or router with the secondcable. Connect to any port on the switch or router except the uplink port.3. Attach the power cord, then plug in the printer and turn it on.4. Set the network IP printer address, or set up the printer for automatic printer IP detection. For moreinformation, refer to the System Administrator Guide at www.xerox.com/office/VLC70XXdocs.Connecting to a Wireless NetworkA wireless local area network (WLAN) provides the means to connect two or more devices in a LANwithout a physical connection. The printer can connect to a wireless LAN that includes a wireless routeror wireless access point. Before connecting the printer to a wireless network, the wireless router must beconfigured with a service set identifier (SSID) and any necessary credentials.Note: Wireless networking is available only on printers with the optional Wireless Network Adapterinstalled.
