No.(Addr.Hex) Name Description Values PageH5-04(428) Stopping Method afterCommunication Error (CE)All Modes0: Ramp to stop1: Coast to stop2: Fast Stop3: Alarm onlyDefault: 0Range: 0 to 3 123H5-05(429) Communication FaultDetection SelectionAll Modes0: Disabled1: Enabled. If communication is lost for more than two seconds, a CE faultwill occur.Default: 0Range: 0, 1 123H5-06(42A) Drive Transmit Wait Time All ModesSet the wait time between receiving and sending data.Default: 5 msMin.: 5Max.: 65 123H5-07(42B) RTS Control SelectionAll Modes0: Disabled. RTS is always on.1: Enabled. RTS turns on only when sending.Default: 1Range: 0, 1 124H5-09(435) CE Detection TimeAll ModesSets the time required to detect a communications error.Adjustment may be needed when networking several drives.Default: 2.0 sMin.: 0.0Max.: 10.0 124H5-10(436)Unit Selection forMEMOBUS/ModbusRegister 0025HAll Modes0: 0.1 V units1: 1 V unitsDefault: 0Range: 0, 1 124H5-11(43C) Communications ENTERFunction SelectionAll Modes0: Drive requires an Enter command before accepting any changes toparameter settings.1: Parameter changes are activated immediately without the Enter command(same as V7).Default: 1Range: 0, 1 124H5-12(43D) Run Command MethodSelectionAll Modes0: FWD/Stop, REV/Stop1: Run/Stop, FWD/REVDefault: 0Range: 0, 1 124<1> If this parameter is set to 0, the drive will be unable to respond to MEMOBUS/Modbus commands.u H6: Pulse Train Input/OutputNo.(Addr.Hex) Name Description Values PageH6-01(42C) Pulse Train Input TerminalRP Function SelectionAll Modes0: Frequency reference1: PID feedback value2: PID setpoint value3: V/f Control with Simple PG feedback (possible only when using motor 1in V/f Control)Default: 0Range: 0 to 3 125H6-02(42D) Pulse Train Input ScalingAll ModesSets the terminal RP input signal frequency that is equal to 100% of the valueselected in H6-01.Default: 1440 HzMin.: 1000Max.: 32000 126H6-03(42E) Pulse Train Input GainAll ModesSets the level of the value selected in H6-01 when a frequency with the valueset in H6-02 is input.Default: 100.0%Min.: 0.0Max.: 1000.0 126H6-04(42F) Pulse Train Input BiasAll ModesSets the level of the value selected in H6-01 when 0 Hz is input.Default: 0.0%Min.: -100.0Max.: 100.0 126H6-05(430) Pulse Train Input Filter TimeAll ModesSets the pulse train input filter time constant.Default: 0.10 sMin.: 0.00Max.: 2.00 126A.9 H Parameters: Multi-Function Terminals280 YASKAWA ELECTRIC SIEP YEAHHP 01B YASKAWA AC Drive – A1000 HHP Programming Manual
