1 EnglishYASKAWA TOMPC71061753A YASKAWA AC Drive GA500 Installation and Operation Instruction 17Symbol Name FunctionMDWEZ LED Illuminated: The drive is In DriveWorksEZ operation.N RJ-45 Connector Connects to the drive. Use an RJ-45 8-pin straight through UTP CAT5e extension cable toinstall the keypad in a different location than the drive.WARNING Sudden Movement Hazard. If you change the control source when b1-07 = 1 [LOCAL/REMOTE Run Selection = Accept Existing RUN Command], the drive can start suddenly. Before you change thecontrol source, remove all personnel from the area around the drive, motor, and load. Sudden starts can causeserious injury or death.◆ InstallationWARNING Fire Hazard. Do not put flammable or combustible materials on top of the drive and do notinstall the drive near flammable or combustible materials. Attach the drive to metal or other noncombustiblematerial. Flammable and combustible materials can start a fire and cause serious injury or death.CAUTION Crush Hazard. Tighten terminal cover screws and hold the case safely when you move thedrive. If the drive or covers fall, it can cause moderate injury.NOTICE Install the drive as specified by EMC Guidelines. If you do not obey the EMC Guidelines, itcan cause incorrect operation and damage to electrical devices.NOTICE Do not let unwanted objects, for example metal shavings or wire clippings, fall into thedrive during drive installation. Put a temporary cover over the drive during installation. Remove the temporarycover before start-up. Unwanted objects inside of the drive can cause damage to the drive.NOTICE Obey correct electrostatic discharge (ESD) procedures when you touch the drive.Incorrect ESD procedures can cause damage to the drive circuitry.Note:Do not put drive peripheral devices, transformers, or other electronics near the drive. Shield the drive from electricalinterference if components must be near the drive. Components near the drive can cause incorrect drive operation fromelectrical interference.■ Installation EnvironmentThe installation environment is important for the lifespan of the product and to make sure thatthe drive performance is correct. Make sure that the installation environment agrees with thesespecifications.Environment ConditionsArea of Use IndoorsPower Supply Overvoltage Category IIIAmbientTemperatureSettingIP20/UL Open Type: -10°C to +50 °C (14 °F to 122 °F)IP20/UL Type1: -10 °C to +40 °C (14 °F to 104 °F)• Drive reliability is better in environments that do not have wide temperature fluctuations.• When installing the drive in an enclosure, use a cooling fan or air conditioner to keep the internalair temperature in the permitted range.• Do not let the drive freeze.Humidity 95%RH or lessDo not let condensation form on the drive.StorageTemperature-20 °C to +70 °C (-4 °F to +158 °F) (short-term temperature during transportation)
