YASKAWA NX100 Instruction Manual
Also see for MOTOMAN DX100: InstructionsInstructionsInstructionsInstruction manualInstruction manual
                                                                                        | |
Contents
| 
Fieldbus PCI-CardPROFIBUS network setupSerial interfacePin SignalHousing PE1 -2 RxD3 TxD4 -5 GND6 -7 -8 -9 -6.3 PROFIBUS network setupTo be able to setup the PROFIBUS fieldbus network, the AnyBus NetTool for PROFIBUS isrecommended to use.6.3.1 AnyBus NetTool for PROFIBUSAnybus NetTool for Profibus is a configuration tool to create complete Profibus-DP networkconfigurations. The graphical workbench of NetTool allows the compilation of Profibus networkconfigurations based on slave GS*-files. By online functionality the Profibus configuration can bedownloaded to the master module and the I/O-data of the connected slaves be monitored andmodified.The configuration tool includes all necessary software and a hardware interface to configure, manageand troubleshoot your PROFIBUS network.• When installed, go to the Help-menu where all necessary information/guidelines for the setup canbe found.6.3.2 TerminationThe end nodes(first and last nodes) in a PROFIBUS network must be terminated to avoid reflectionson the bus line.• Attach a terminating resistor, equal to 220 ohms, to each end of the data transfer cable. Theresistors are connected across the A- and B-lines(Pin 8 and 3 of the SUB-D connector).CautionIf you do not use terminating resistors as described, the PROFIBUS cable system will NOToperate properly6.3.3 Node settingsAll nodes have to be, by hardware, setup according to the configuration defined in the software. Thekind of setting device is varying, depending on which manufacturer used.Reg.No. ME00107EN-02 Page 31 |
Related manuals for YASKAWA MOTOMAN DX100
This manual is suitable for:
manualsdatabase
Your AI-powered manual search engine