YASKAWA SI-EP3 Technical Manual

Also see for SI-EP3: Technical manual Installation manual Technical manual Installation manual

Contents

12 YASKAWA ELECTRIC SIEP C730600 89C YASKAWA AC Drive Option SI-EP3 Technical Manual5 Installation Procedure5 Installation Procedure Section SafetyDANGERElectrical Shock HazardDo not inspect, connect, or disconnect any wiring while the drive is energized.Failure to comply will cause death or serious injury.Before servicing, disconnect all power to the equipment and wait for at least the time specified on the warning label.The internal capacitor remains charged even after the drive is de-energized. The charge indicator LED will extinguishwhen the DC bus voltage is below 50 Vdc. When all indicators are OFF, measure for unsafe voltages to confirm thedrive is safe.WARNINGElectrical Shock HazardDo not operate equipment with covers removed.Failure to comply could cause death or serious injury.The diagrams in this section may include options and drives without covers or safety shields to illustrate details.Reinstall covers and shields before operating the drive and run the drive according to the instructions described in thismanual.Do not allow unqualified personnel to perform work on the drive or option.Failure to comply could cause death or serious injury.Only authorized personnel familiar with installation, adjustment, and maintenance of AC drives and options mayperform work.Do not remove covers or touch circuit boards while the drive is energized.Failure to comply could cause death or serious injury.Do not use damaged wires, stress the wiring, or damage the wire insulation.Failure to comply could cause death or serious injury.Fire HazardTighten all terminal screws to the specified tightening torque.Loose or overtightened connections could cause erroneous operation and damage to the terminal block or start a fireand cause death or serious injury.NOTICEDamage to EquipmentObserve proper electrostatic discharge (ESD) procedures when handling the option, drive, and circuit boards.Failure to comply could cause ESD damage to circuitry.Never connect or disconnect the motor from the drive while the drive is outputting voltage.Improper equipment sequencing could damage the drive.Do not connect or operate any equipment with visible damage or missing parts.Failure to comply could further damage the equipment.Do not use unshielded wire for control wiring.Failure to comply may cause electrical interference resulting in poor system performance. Use shielded, twisted-pairwires and ground the shield to the ground terminal of the drive.