54 YASKAWA ELECTRIC SIEP C730600 89C YASKAWA AC Drive Option SI-EP3 Technical Manual11 European Standards11 European StandardsFigure 26Figure 27 CE MarkThe CE mark indicates compliance with European safety and environmental regulations. It is required for engaging inbusiness and commerce in Europe.European standards include the Machinery Directive for machine manufacturers, the Low Voltage Directive forelectronics manufacturers, and the EMC guidelines for controlling noise.This option displays the CE mark based on the EMC guidelines.EMC Guidelines: 2014/30/EUDrives used in combination with this option and devices used in combination with the drive must also be CE certified anddisplay the CE mark. When using drives displaying the CE mark in combination with other devices, it is ultimately theresponsibility of the user to ensure compliance with CE standards. Verify that conditions meet European standards aftersetting up the device. EMC Guidelines ComplianceThis option is tested according to European standards EN 61800-3:2004/A1:2012 and complies with EMC guidelines.The CE marking is declared based on the harmonized standards. EMC Guidelines Installation ConditionsVerify the following installation conditions to ensure that other devices and machinery used in combination with thisoption and drives also comply with EMC guidelines:1. Use dedicated shield cable for the option and external device (encoder, I/O device, master), or run the wiringthrough a metal conduit.2. Keep wiring as short as possible and ground the largest possible surface area of the shield to the metal panelaccording to Figure 29.Figure 27Figure 28 Ground AreaA – Braided shield cable C – Cable clamp(conductive)B – Metal panelC BA