YASKAWA SI-ES3 Installation Manual

Also see for SI-ES3: Installation manual Technical manual

Contents

5 Mechanical & Electrical InstallationYASKAWA TOEPYEUOEC101A EtherCAT Option Installation Manual 191. Affix the LED label (E) in the appropriate position on the drive front cover (D).Figure 5.13 Affix the LED Label2. Turn off the power. Wait until the CHARGE LED turns off and then remove the cover. Refer to the drivemanual for direction on removing the front cover.3. Move the keypad connector to the holder on the drive after removing the keypad and before removing thefront cover. Insert the keypad connector tab into the holder when installing the keypad connector to theholder.Figure 5.14 Remove the Front Cover and Keypad4. Carefully remove the USB port board (H) and place it on the right side of the drive using the temporaryplacement holes. Do not remove the USB port board cable connector.Figure 5.15 Remove the USB Port Board5. Insert the option card (B) into the CN5-A connector (I) on the drive and fasten it into place using the in-cluded screws (C). Tighten both screws to 0.5 to 0.6 Nm (4.4 to 5.3 in. lbs).Note:Installing the option card on a Q2A drive requires only two screws and does not require a ground wire. The option packageships with three screws and a ground wire for installation on other drive series. Do not use the ground wire or the extra screw.DEHTemporary placement holes