4.4 Basic Parameter AdjustmentsYASKAWA TM.V1000.01 V1000 Drive Installation & Start-Up Manual (Preliminary 01-19-07) 153Start-Up Programming &Operation4◆ Analog Outputs: H4-01 to H4-03Group U parameters can be used to observe the drive status (operating conditions)through the LED operator. Analog outputs corresponding to these monitors can beobtained on analog output terminal AM or Fm when programmed with parametergroup H4. Some Group U monitors are not available as analog outputs.■ Changing Analog Output SettingsThe following example illustrates how to program analog output terminal FM togenerate a signal proportional to drive output current (monitor U1-03).Using H4-01 to Display Monitor ContentsNo. Parameter Name Description PageH4-01Multi-Function Analog 1(Terminal AM MonitorSelection)Select the data to be output through multi-function analog outputterminal AM.Set the desired monitor parameter to the digits available inU1-. For example, enter “103” for U1-03.When using this terminal as a through terminal or when not usingit at all, set “000” or “031”.—H4-02<1><1> Indicates that the parameter can be changed during run.Multi-Function Analog 1(Terminal AM OutputGain)Sets terminal AM output level when selected monitor is at 100%.Maximum output voltage is 10 V (can be adjusted with avoltmeter).—H4-03<1>Terminal AM BiasSettingSets the voltage level bias for terminal AM.The bias added is 0 to ±10% with a maximum voltage output of10 V as 100%.—Step Display/Result1. Turn on the power to the drive. The initial display appears. ⇒2. Press until the Parameter setting menu is displayed. ⇒3. Press to enter the Parameter setting menu. ⇒4. Press and to select H4-01. ⇒
