B.2 Parameter Table404 YASKAWA TM.V1000.01 V1000 Drive Installation & Start-Up Manual (Preliminary 01-19-07)◆ r: DWEZ Parameterso4-07Inrush PreventionRelay MaintenanceSettingResets the Inrush Prevention RelayMaintenance Time to 0 (U4-06). 0 to 150 0% A A A 523 —o4-09 IGBT MaintenanceSettingResets the counter that logs the IGBTs usagetime. Refer to U4-07 (IGBT Maintenance). 0 to 150 0% A A A 525 —o4-10 IGBT MaintenanceSettingDisplays “LT-4” when the maintenance periodis passed, activates a multi-function output(H2-
= 10 or 2F) (this display can bechanged during run).0 to150% 50% A A A 526 —o4-11 U2, U3 Initial ValueSelection0: Saves the value for U2-
(Fault Trace)and U3-
(Fault History).1: Resets the values for U2- (Fault Trace) andU3-
(Fault History).0 to 1 0 A A A 510 —o4-12 kWH Monitor InitialValue Selection0: Saves the values of monitor parametersU4-10 and U4-11.1: Resets monitor parameters U4-10 and U4-11back to default settings.0 to 1 0 A A A 512 —o4-13 Motor r/min Reset 0: Maintain the current r/min.1: Reset the number of motor revolutions to 0. 0 to 1 0 A A A 528 —<9> Default setting value is dependent on parameter E1-01, Input Voltage Setting.<11> Default setting value is dependent on parameter o1-03, Digital Operator Display Selection.<12> Default setting value is dependent on parameter o2-04, Drive/kVA Selection.<14> Default setting value is dependent on parameter o2-09, Initialization Spec. Selection.<22> Parameter can be changed during run.No. Name Description Range Def.ControlModeAddr.HexPg.V/fOLVPMr1-01 DWEZ ConnectionParameter 1 (upper) Parameter 1 for connecting DWEZ (upper). 0 toFFFFH 0 – A A 1840 —r1-02 DWEZ ConnectionParameter 1 (lower) Parameter 1 for connecting DWEZ (lower). 0 toFFFFH 0 – A A 1841 —r1-03 DWEZ ConnectionParameter 2 (upper) Parameter 2 for connecting DWEZ (upper). 0 toFFFFH 0 – A A 1842 —No. Name Description Range Def.ControlModeAddr.Hex Pg.V/fOLVPM
